maziggy 61a7f2e4ac feat(scheduler): preheat & heat-soak before queued prints with per-filament chamber targets + airduct flap control (#1468) ...

New scheduler stage that heats the bed (and the chamber, on supported
printers) and holds at temperature before each queued print starts —
the heat-soak engineering filaments need for adhesion and warp
control. Bambuddy waits between FTP upload and start_print, so the
soak runs while the printer is otherwise idle. M191 is silently
ignored by Bambu firmware, so doing this at the orchestration layer
is the only place it works.

Resolution order at dispatch:

1. PrintQueueItem.preheat_override ∈ {inherit, on, off}.
   'off' skips entirely; 'inherit' falls back to the global
   preheat_enabled toggle; 'on' forces the stage even when the
   global is off.

2. chamber_target = item.preheat_chamber_target_override
                 ?? max(filament_map[normalize(t.tray_type)] for loaded slots)
                 ?? 0.
   Mixed PA+PLA picks PA's 50 (max-across-slots — PA's chamber
   requirement is binding, PLA doesn't suffer being warm). PLA-only
   derives 0 and skips the chamber phase automatically.

3. Three hardware tiers for chamber heat:
   - Active chamber heater (H2C/H2D/H2D Pro/H2S/X2D/X1E) → M141 +
     chamber-sensor wait
   - Chamber sensor only (X1C/P2S) → no M141, passive bed-radiation
     wait with hard max-wait cap
   - No chamber sensor (P1S/P1P/A1/A1 Mini) → bed + soak timer only

4. Airduct flap (H2C/H2D/H2D Pro/H2S/X2D/P2S) auto-switches to
   match the chamber target — heating mode for engineering
   filaments, cooling mode for PLA. Bambu firmware does NOT
   auto-switch the flap with M141, so without this an ABS print
   on a previously-cooling flap fights the open exhaust, and a
   PLA print on a previously-hot flap recirculates ABS heat.
   Idempotent: only fires set_airduct_mode when current ≠ desired.

Settings → Workflow → Queue & Dispatch → Preheat & Heat Soak card:
master enable toggle (default off — disabled installs see no change),
per-filament chamber-target editor (replaces a single global int that
shipped in the first cut and couldn't serve PA + PLA in the same
config), preheat_max_wait_seconds, preheat_soak_seconds. The Print
Options panel in PrintModal gets a Preheat sub-section with the
tri-state Inherit/On/Off control and an optional chamber-target
override input.

DB migration: PrintQueueItem gains preheat_override VARCHAR(10)
DEFAULT 'inherit' and preheat_chamber_target_override INTEGER NULL.
Idempotent via _safe_execute. Existing rows behave exactly as before
the migration.

Best-effort throughout: printer drops, refused M141 or set_airduct,
missing bed temp, lost MQTT state mid-wait all log and return cleanly.
Normal upload + start path runs after this returns regardless.

2026-06-29 12:35:43 +02:00

..

routes

feat(scheduler): preheat & heat-soak before queued prints with per-filament chamber targets + airduct flap control (#1468)

2026-06-29 12:35:43 +02:00

__init__.py

…