mirror of
https://github.com/maziggy/bambuddy.git
synced 2026-10-03 04:31:28 +02:00
maziggy
5680f5d34b
Both the queue-side _watchdog_print_start and the direct-dispatch _verify_print_response used `status.state != pre_state` to decide whether a project_file command had been accepted. When a printer was in FINISH at dispatch time (un-dismissed post-print prompt from a prior job), the firmware silently rejected the new command; if the user then dismissed the screen prompt, the printer moved FINISH -> IDLE and the watchdog returned early as "command landed" — leaving the queue row stuck at status='printing' indefinitely and the scheduler permanently marking the printer as busy. Narrow the "command landed" check in both verifiers to an allow-list of active-print states (PREPARE / SLICING / RUNNING / PAUSE). Inactive transitions (FINISH -> IDLE, etc.) no longer short-circuit the revert. The subtask_id-advance signal stays in place for H2D's slow FINISH -> PREPARE transition (#1078). Also wrap _watchdog_print_start's revert commit and printer_manager._persist_awaiting_plate_clear in run_with_retry so SQLite single-writer contention can't silently drop these writes. The revert path returns a tristate sentinel so the post-revert MQTT session-recovery logic only runs when we actually reverted (or the commit failed) — not when on_print_complete had already cleared the row, where a forced reconnect could break a healthy concurrent print.