mirror of
https://github.com/maziggy/bambuddy.git
synced 2026-09-30 19:21:33 +02:00
maziggy
0d21239e18
Assigning a spool to an AMS slot unassigned it again seconds later, and
the slot's colour changed at the same time. It presented as Bambu Studio
and Bambuddy fighting over the slot. The reporter's log shows Bambuddy
losing to itself.
P1S firmware 01.10.00.00 reads every lowercase hex letter in an AMS
tray_color as a zero, and hides it completely: the command response
echoes back the value that was sent and reports result "success", so
only the next AMS push says what was really stored. The spool-assign
path sent spool.rgba verbatim and that column stores lowercase. From the
bundle:
sent 09ff00ff -> AMS reports 09000000
sent ff5100ff -> AMS reports 00510000
sent 090000FF -> AMS reports 090000FF
That is the visible colour change, and it is also what deleted the
assignment. The auto-unlink sweep asks whether the slot still matches
the spool assigned to it; the mangled colour no longer did, so the
assignment Bambuddy had made four seconds earlier was removed.
colors_similar('09000000', '09FF00FF') is False, which is the whole of
it.
Re-assigning could not recover, because the Configure Slot dialog seeds
its colour from whatever the printer currently reports. It wrote the
mangled colour back and cemented it, which is the loop the report
describes in its steps 4 and 5.
Colours are now uppercased where the command is assembled rather than in
each of the four routes that configure a slot. A caller that forgets is
exactly how this arrived. Nothing else changes: no padding, no invented
alpha, no six-to-eight widening, and tray_type and tray_sub_brands keep
their case, where it carries meaning -- "PLA Matte" is a product line,
"PLA MATTE" is not.
Two paths deliberately left alone. The developer-mode probe re-sends the
colour the printer itself just reported so that the probe is inert;
uppercasing there would turn it into a write. And the Virtual Printer
forwards the slicer's own command verbatim -- Studio could in principle
hit the same firmware bug, but nothing here evidences that it sends
lowercase, and rewriting a slicer payload inside a transparent proxy is
not a change to make on a hunch.
Two more defects from the same log.
A spool with a brand and no subtype was configured with the string
"None" in its name: the branded branch interpolated spool.subtype
without checking it while the unbranded branch guarded it, so
"Sunlu PLA Matte None" went on the wire and into Studio's display.
And the FTP log is readable again. A 426 whose bytes Bambuddy has
already verified against the printer is how Bambu FTPS normally ends a
transfer, not a fault, so it drops from WARNING to INFO. It fired 54
times in this one bundle, every one followed by a completed upload, and
it was burying the 26 TLS handshake failures in the same log that
actually cost the reporter two prints. A 426 whose bytes do not verify
is still an error and still fails the upload.
The handshake failures themselves are printer-side FTPS cool-off under
load and are not touched here.